电梯套门

安装电梯门套注意事项: 
 1、单台电梯要注意首层两侧出墙距离应一致。(如果只有首层有的话) 
 2、多台电梯安装要保证出墙的距离一致外,所有大门套外侧边缘应在一个平面上。 
3、如果每层都有大门套,那么要安装厅门后再订做厅门套。  
4、切记,安装大门套之前应问建筑方是否有地轴线,因为井道中心线未必与地轴线平行。因为建筑有误差,所以要先问好此事,否则将带来不必要的麻烦。 
5、如有装饰层还应问装饰层的厚度。  
6、遇到其它具体情况应按甲方要求去做或协商。
Use wrong tooth design, to prevent the occurrence of clearance adjacent cascade, put an end to the existence of potential safety hazard,
Install the elevator door cover note 
1, a single elevator should pay attention to the first floor on both sides of the wall distance should be consistent. (if any) only the first layer 
2, many sets of elevator installation to ensure that the distance of the wall is consistent, all door outer edge should be on a plane. 
3, if the door of each layer, so you want to install custom hall door cover again the hall door. 
4, keep in mind, should ask before to install door of architects have to axis, because and the shaft centerline is not parallel to the axis. Because buildings have error, so want to say hello first, otherwise will bring unnecessary trouble. 
5, if you have any adornment layer should also ask adornment layer thickness. 6, meet other details should be in accordance with the requirements of party a to do or to negotiate.


上一条:电梯门套2
下一条:电梯门套4